What Is The Harley Crankshaft Position Sensor - Where Is The Harley Softail CKP - Here I talk about the crankshaft position sensor on the Harley Davidson Mil
AF sensor signal variation; Spark kilovolt (kV) amplitude; Any one of these strategies could be at play when it comes to misfire detection. In fact, some vehicles will implement more than one strategy, depending on vehicle operating conditions (idle vs. highway/cruise speed). CKP sensor signal frequency. This strategy is most used.
The ECM/PCM can monitor cam position using these signals - note the missing tooth on the crank sensor pattern - using that missing tooth and the cam sensor signals, the ECM/PCM can determine (and adjust) camshaft indexing. If one of the cam sensor signals flatlines or becomes "scratchy," a code will be set. Products Mentioned in this Guide
A crankshaft angle sensor is designed to detect the rotation of the crankshaft while the engine is running and is responsible for triggering the fuel injection and ignition system via the main PCM computer.This crank sensor will be located at the lower section of the block and can either be at the front, rear or middle of the engine at the crankshaft level. Step 1: Prepare the vehicle. Jack the vehicle up high enough to obtain access to the crankshaft position sensor. Secure the vehicle in this position using jack stands. Step 2: Disconnect the electrical connector. Unplug the sensor's electrical connector from the engine wiring harness. Step 3: Locate and remove the crankshaft position sensor. IoqfDH. 433 389 282 72 350 466 396 225 467